Messages Reference Guide

ManualsBrandsDell ManualsComputersChassis Management Controller Version 1.0 for PowerEdge VRTX

571

572

573

574

575

576

577

578

579

580

Detailed

Description

The Chassis Management Controller is unable to communicate with the iDRAC service

processor for the Server identified in the message and the Server could not be turned off. This

situation may occur when iDRAC is rebooting.

Recommended

Response Action

Do the following: 1) Wait for a few minutes for the iDRAC service processor to complete

startup. 2) Retry the operation. 3) If the issue persists, reset the iDRAC and wait a few minutes

for the iDRAC startup to complete before retrying the operation.

Category Audit

SubCategory PWR = Power Usage

Severity Severity 1 (Critical)

Trap/EventID 8417

LCD Message No LCD message display defined.

Initial Default. SNMP Alert;#EMAIL Alert;#LC Log;#Remote System Log

Filter

Visibility

IPMI Alert SNMP

Alert

LC Log LCD Power Off Power

Cycle

Reset

TRUE FALSE TRUE TRUE TRUE FALSE FALSE FALSE FALSE

PWR8566

Message Unable to turn off the Server

arg1

before the Power Off timer expired.

Arguments

•

arg1 =

server number

Detailed

Description

Unable to turn off the Server before the Power Off timer has expired. This happens if the Server

did not show "power off" status change within 30 seconds after the operation was initiated.

This situation may also occur when iDRAC is rebooting.

Recommended

Response Action

The Server may need more time to turn off. Wait for ten seconds and check the power status. If

the Server was not turned off, retry the operation. If the issue persists, remove and reinsert the

Server, wait for the iDRAC to complete startup, and retry the operation.