Messages Reference Guide

Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
LC0100
Message Lifecycle Controller has entered Recovery mode.
Detailed
Description
A persistent error has occurred while carrying out a Lifecycle Controller operation. This
situation causes Lifecycle Controller to enter Recovery mode. Any remote jobs pending
execution were cancelled.
Recommended
Response Action
To verify or change Recovery mode, use F2 Setup, select iDRAC Configuration, and select
Lifecycle Controller Settings. Updating Lifecycle Controller clears the Recovery mode.
Category Configuration
SubCategory LC = Lifecycle Contr
Severity Severity 2 (Warning)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
LC0101
Message Lifecycle Controller action was cancelled by a user.
Detailed
Description
A user cancelled Lifecycle Controller actions. Any remote jobs pending execution were
cancelled.
Recommended
Response Action
No response action is required.
Category Configuration
SubCategory LC = Lifecycle Contr
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
328