Messages Reference Guide
Recommended
Response Action
Identify and replace the failed component. To identify the failed component, select the
enclosure in the tree view and click the Health subtab. Any failed component will be identified
with a red X on the enclosures Health subtab. Alternatively, you can select the Storage object
and click the Health subtab. The controller status displayed on the Health subtab indicates
whether a controller has a failed or degraded component. See the enclosure documentation
for information on replacing enclosure components and for other diagnostic information.
Category Storage
SubCategory ENC = Storage Enclosr
Severity Severity 2 (Warning)
Trap/EventID 4338
LCD Message No LCD message display defined.
Initial Default. SNMP Alert;#LCD;#Remote System Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
TRUE FALSE TRUE TRUE TRUE TRUE FALSE FALSE FALSE
ENC6
Message Communication timeout on
arg1
.
Arguments
•
arg1 =
Enclosure Name
Detailed
Description
The controller is unable to communicate with an enclosure. There are several reasons for
communication loss. For example, there may be a bad or loose cable. An unusual amount of I/O
may also interrupt communication with the enclosure. In addition, communication loss may be
caused by software, hardware, or firmware problems, bad or failed power supplies, and
enclosure shutdown.
Recommended
Response Action
Check for problems with the cables. See the Cables attached correctly section for more
information on checking the cables. You should also check to see if the enclosure has
degraded or failed components. To do this, select the enclosure object in the tree view and
click the Health subtab. The Health subtab displays the status of the enclosure components.
Verify that the controller has the supported driver and firmware versions installed and that
each Enclosure Management Modules (EMMs) are running the same version of supported
firmware.
Category Storage
SubCategory ENC = Storage Enclosr
Severity Severity 2 (Warning)
Trap/EventID 4338
LCD Message No LCD message display defined.
Initial Default. SNMP Alert;#LCD;#Remote System Log
214