Users Guide

Obtaining a Value for MIB Objects
To obtain a value for any of the MIB objects, use the following command.
• Get a copy-config MIB object value.
snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address
[OID.index | mib-object.index]
index: the index value used in the snmpset command used to complete the copy operation.
NOTE: You can use the entire OID rather than the object name. Use the form: OID.index.
Examples of Getting a MIB Object Value
The following examples show the snmpget command to obtain a MIB object value. These examples
assume that:
• the server OS is UNIX
• you are using SNMP version 2c
• the community name is public
• the file f10-copy-config.mib is in the current directory
NOTE: In UNIX, enter the snmpset command for help using this command.
The following examples show the command syntax using MIB object names and the same command
using the object OIDs. In both cases, the same index number used in the snmpset command follows the
object.
The following example shows getting a MIB object value using the object name.
> snmpget -v 2c -c private -m ./f10-copy-config.mib 10.11.131.140
copyTimeCompleted.110
FTOS-COPY-CONFIG-MIB::copyTimeCompleted.110 = Timeticks: (1179831) 3:16:38.31
The following example shows getting a MIB object value using the OID.
> snmpget -v 2c -c private 10.11.131.140 .1.3.6.1.4.1.6027.3.5.1.1.1.1.13.110
SNMPv2-SMI::enterprises.6027.3.5.1.1.1.1.13.110 = Timeticks: (1179831)
3:16:38.31
Manage VLANs using SNMP
The qBridgeMIB managed objects in Q-BRIDGE-MIB, defined in RFC 2674, allows you to use SNMP to
manage VLANs.
Creating a VLAN
To create a VLAN, use the dot1qVlanStaticRowStatus object.
The snmpset operation shown in the following example creates VLAN 10 by specifying a value of 4 for
instance 10 of the dot1qVlanStaticRowStatus object.
Example of Creating a VLAN using SNMP
> snmpset -v2c -c mycommunity 123.45.6.78 .1.3.6.1.2.1.17.7.1.4.3.1.5.10 i 4
SNMPv2-SMI::mib-2.17.7.1.4.3.1.5.10 = INTEGER: 4
982
Simple Network Management Protocol (SNMP)