Users Guide

– For the management interface, enter the keyword ManagementEthernet 0/0. The slot number
is 0; the port number is 0.
– For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port
information.
– For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
– For a port extender (PE) Gigabit Ethernet interface, enter the keyword peGigE then the pe-id /
stack-unit / port-id
where pe-id is a port-extender ID number from 0 to 255; unit-number is a PE stack-unit number
from 0 to 7; port-id is a port number from 1 to 48.
– For a VLAN, enter the keyword vlan then a number.
– (OPTIONAL) To clear statistics for all VRRP groups configured, enter the keyword vrrp. Enter a
number from 1 to 255 as the vrid.
– (OPTIONAL) To clear unknown source address (SA) drop counters when you configure the MAC
learning limit on the interface, enter the keywords learning-limit.
Example of the clear counters Command
When you enter this command, confirm that you want to clear the interface counters for the specified
interface.
Dell#clear counters te 0/0
Clear counters on TengigabitEthernet 0/0 [confirm]
Dell#
506
Interfaces