Users Guide

Examples of Working with Route Maps
The default action is permit and the default sequence number starts at 10. When you use the keyword
deny in configuring a route map, routes that meet the match filters are not redistributed.
To view the configuration, use the show config command in ROUTE-MAP mode.
The following example shows viewing a configured route-map.
Dell(config-route-map)#show config
!
route-map dilling permit 10
Dell(config-route-map)#
You can create multiple instances of this route map by using the sequence number option to place the
route maps in the correct order. The system processes the route maps with the lowest sequence number
first. When a configured route map is applied to a command, such as
redistribute, traffic passes
through all instances of that route map until a match is found. The following is an example with two
instances of a route map.
Dell#show route-map
route-map zakho, permit, sequence 10
Match clauses:
Set clauses:
route-map zakho, permit, sequence 20
Match clauses:
interface TengigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
Dell#
To delete all instances of that route map, use the no route-map map-name command. To delete just
one instance, add the sequence number to the command syntax.
Dell(conf)#no route-map zakho 10
Dell(conf)#end
Dell#show route-map
route-map zakho, permit, sequence 20
Match clauses:
interface TengigabitEthernet 0/1
Set clauses:
tag 35
level stub-area
Dell#
The following example shows a route map with multiple instances. The show config command displays
only the configuration of the current route map instance. To view all instances of a specific route map,
use the show route-map command.
Dell#show route-map dilling
route-map dilling, permit, sequence 10
Match clauses:
Set clauses:
route-map dilling, permit, sequence 15
Match clauses:
interface Loopback 23
Set clauses:
tag 3444
Dell#
Access Control Lists (ACLs)
145