Setup Guide

=========================================================
Processor 5Sec 1Min 5Min
High Low High Low High Low
=========================================================
CP 50 50 85 75 80 70
RP 0 0 85 75 80 70
LP 0 0 0 85 75 80 70
LP 1 0 0 85 75 80 70
LP 2 0 0 85 75 80 70
LP 3 0 0 85 75 80 70
LP 4 0 0 85 75 80 70
LP 5 0 0 85 75 80 70
LP 6 0 0 85 75 80 70
LP 7 0 0 85 75 80 70
LP 8 0 0 85 75 80 70
LP 9 0 0 85 75 80 70
LP 10 0 0 85 75 80 70
LP 11 0 0 85 75 80 70
PE 0 0 85 75 80 70
Conguring Threshold Memory Utilization for SNMP
Traps
When the total memory utilization for a CPU exceeds the congured high/low threshold for a given time, a threshold notication is sent as
an SNMP trap. If a low threshold value is not specied, the low threshold value is set to the same value as the high threshold value. Use the
util-threshold memory command to congure the high or low memory utilization threshold for SNMP traps.
Use the util-threshold memory command to congure the high or low memory utilization threshold for SNMP traps. Use the show
util-threshold memory to display the congured values of memory utilization thresholds.
Parameters
• cp — Enter the keyword cp to congure the memory utilization threshold for the Control Processor CPU.
• rp — Enter the keyword rp to congure the memory utilization threshold time for the Route Processor CPU
• lp — Enter the keyword lp to congure the linecard processor memory utilization threshold time. The range of switch slot IDs is from 0
to 2.
• pe — Enter the keyword, pe to congure the CPU memory utilization time for of all PEs that are congured in the system.
• all — Enter the keyword all to congure the memory utilization threshold on all switch CPUs: Control Processor, Route Processor,
PE, and line cards.
• {{high | low} cpu-utilization-threshold-percentage} — Enter a percentage value to congure the high or low threshold level for the
percentage of memory a switch CPU can used. The percentage of CPU use ranges from 0 to 100.
Defaults
– High threshold: 92%
– Low threshold: 82%
NOTE
: A threshold level of 0 disables Syslog and SNMP traps.
• Congure the high or low memory utilization thresholds for SNMP traps.
CONFIGURATION mode
util—threshold memory {5 sec | 1 min | 5 min} {cp |rp | lp | pe | all} {high {0-100} | low
{0-100}}
Example of Conguring CPU Utilization Threshold
To display the congured values of memory utilization thresholds, use the show util-threshold memory command from
CONFIGURATION mode.
Dell(conf)#util-threshold memory ?
all All processors in the system
Simple Network Management Protocol (SNMP)
987