Reference Guide

0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
Output Statistics:
0 packets, 0 bytes 0 underruns
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-
byte pkts
0 Multicasts, 0 Broadcasts 0 Unicasts
0 throttles, 0 discarded, 0 collisions 0 wredDrops
0 Green WredDrops 0 Yellow WredDrops, 0 Red WredDrops
Rate info (interval 15 seconds):
Input 00.00 Mbits/sec, 0 packets/sec, 0.00% of
line-rate
Output 00.00 Mbits/sec, 0 packets/sec, 0.00% of
line-rate
Related
Commands
show hardware hg-stats — displays traffic statistics from internal ports in a HiGig
link bundle.
hg-link-bundle-monitor enable
Enable the monitoring of link utilization and traffic distribution in backplane HiGig link bundles/port
channels on a line-card or switch fabric module (SFM) NPU.
C9000 Series
Syntax
hg-link-bundle-monitor {sfm npu-id hg-port—channel hg-port—
channel-id | slot slot npuUnit npu-id hg-port—channel 0} enable
To disable HiGig link-bundle monitoring, use the no version of this command.
Parameters
sfm npu-id hg-
port-channel hg-
port-channel-id
Specify a HiGig port channel on a switch SFM (spine) NPU
by entering the keyword sfm and SFM NPU ID, then hg-
port-channel and a HiGig port channel ID. SFM NPU IDs
are 0 to 1; SFM HiGig port-channel IDs are 0 to 10.
slot slot-id
npuUnit npu-id
hg-port-channel
0
Specify a HiGig port channel on a line-card (leaf) NPU by
entering the keyword slot and slot number, then npuUnit
and line-card NPU ID, then hg-port-channel 0. Line-
card slot numbers are 0 to 11; line-card NPU ID is 0 . The
HiGig port-channel ID range is from 0 to 2.
enable Enable HiGig link-bundle monitoring.
Command Mode CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.3.0.0 Introduced on the Z9000 switch.
Interfaces
969