Reference Guide

Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE
mode, where you can set the access conditions for the designated line.
C9000 Series
Syntax
line {console 0 | vty number [end-number]}
Parameters
console 0 Enter the keyword console 0 to configure the console
port. The console option for the S-Series is <0-0>.
vty number Enter the keyword vty then a number from 0 to 9 to
configure a virtual terminal line for Telnet sessions. The
system supports 10 Telnet sessions.
end-number (OPTIONAL) Enter a number from 1 to 9 as the last virtual
terminal line to configure. You can configure multiple lines
at one time.
Defaults Not configured
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
96
Control and Monitoring