Reference Guide

switchport
no shutdown
Dell(conf-if-range-te-1/1-2)#
show interfaces
Display information on a specific physical or virtual interface, or the interfaces of the same type on a line
card.
C9000 Series
Syntax
show interfaces [interface] [linecard slot-id]
From a PE console, use show interfaces to view the information on a specific
physical or virtual interface.
Parameters
interface Enter one of the following keywords and slot/port or
number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Null interface, enter the keywords null 0.
• For a Port Channel interface, enter the keywords port-
channel
then a number. The range is 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then
the tunnel ID. The range is from 1 to 16383.
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
NOTE: The peGigE option is only visible when the
feature extended bridge feature is enabled.
linecard slot-id Enter the linecard slot-id parameters to specify the
switch ports on a line card. The range of slot IDs is from 0 to
11.
Command Modes
• EXEC
• EXEC Privilege
Interfaces
897