Reference Guide

Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S4810, S4820T, S6000, S6000–ON,
Z9000, and Z9500.
Usage Information
Use this command on the interfaces where the DHCP clients are connected to
forward the packets from clients to DHCP server and vice-versa.
Example
Dell(conf-if-te-0/0)#ipv6 helper-address
X:X:X:X::X IPv6 helper address
lease
Specify a lease time for the addresses in a pool.
C9000 Series
Syntax
lease {days [hours] [minutes] | infinite}
Parameters
days Enter the number of days of the lease. The range is from 0
to 31.
hours Enter the number of hours of the lease. The range is from 0
to 23.
minutes Enter the number of minutes of the lease. The range is from
0 to 59.
infinite Specify that the lease never expires.
Defaults 24 hours
Command Modes DHCP <POOL>
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Inroduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
Dynamic Host Configuration Protocol (DHCP)
767