Reference Guide

stack-unit unit-
number
Enter the keyword stack-unit and the stack unit number. The range
is from 0 to 7.
port-set port-pipe Enter the keywords port-set port-pipe parameters to specify a
port pipe (set of ports) on a line card. The range of port-pipe numbers
is 0.
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the
relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.0 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
Example
Dell#show hardware ip eg-acl linecard 0 port-set 0
EID 0x000011b9: gid=0xf,
slice=2, slice_idx=0, part =0 prio=0x11b9, flags=0x10202,
Installed, Enabled
tcam: color_indep=0,
StageEgress
Color
Offset: 5 Width: 2
DATA=0x00000001
MASK=0x00000003
action={act=RpDrop, param0=0(0), param1=0(0), param2=0(0),
param3=0(0)}
policer=
statistics={stat id 64 slice = 2 idx=1 entries=1}{Packets}
EID 0x000011b8: gid=0xf,
slice=2, slice_idx=0x1, part =0 prio=0x11b8, flags=0x10202,
Installed, Enabled
tcam: color_indep=0,
StageEgress
IpType
Offset: 192 Width: 4
DATA=0x00000000
MASK=0x0000000e
L3Routable
Offset: 156 Width: 1
DATA=0x00000001
MASK=0x00000001
OutPort
Offset: 185 Width: 7
742
Debugging and Diagnostics