Reference Guide

{4|8} | fcoe
number
[iscsioptacl
number] [vrfv4acl
number]
stored in the NVRAM and is effective after rebooting the
switch.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Added the nlbcluster ACL keyword. Introduced on the
S6000-ON.
9.4.(0.0) Added support for PBR and VRF.
9.2(1.0) Introduced on the Z9500.
9.2(0.2) Added support for fcoe.
9.1.(0.0) Added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.2 Clarified block information for the S4810.
8.3.10.0 Introduced on the S4810.
8.3.1.0 Added the keywords ecfmacl, vman-qos, and vman-
dual-qos.
8.2.1.0 Introduced on the S-Series.
7.8.1.0 Introduced on the C-Series.
Usage Information
Save the new CAM settings to the startup-config (write-mem or copy run
start) then reload the system for the new settings to take effect.
The total amount of space allowed is 16 FP Blocks. System flow requires three
blocks; these blocks cannot be reallocated. Only 12 number of blocks can be
configured by the user .
There can be only one odd number of Blocks in the CLI configuration; the other
Blocks must be in factors of 2. For example, a CLI configuration of 5+4+2+1+1
Blocks is not supported; a configuration of 6+4+2+1 Blocks is supported.
The ipv6acl allocation must be a factor of 2.
Content Addressable Memory (CAM)
607