Reference Guide

redistribute ospf
Redistribute OSPFv3 routes into BGP.
C9000 Series
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match
internal]] [route-map map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf
process-id command.
Parameters
process-id Enter the number of the OSPFv3 process. The range is 1 to
65535.
match external {1 |
2}
(OPTIONAL) Enter the keywords match external to
redistribute OSPF external routes. You can specify 1 or 2 to
redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to
redistribute OSPFv3 internal routes only.
route-map map-
name
(OPTIONAL) Enter the keywords route-map followed by
the name of an established route map. Only the following
ROUTE-MAP mode commands are supported:
• match ipv6 address
• match ipv6 next-hop
• match ipv6 route-source
• set ipv6 next-hop
If you do not configure the route map, the default is deny
(to drop all routes).
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information When you enter the redistribute ospf process-id command without any
other parameters, the software redistributes all OSPF internal routes, external type 1
routes, and external type 2 routes.
586
Border Gateway Protocol