Reference Guide

dependent; therefore, if you configure one parameter, you must configure the
parameters in the order they appear in the command.
Related
Commands
show ip bgp dampened-paths – views the BGP paths.
bgp default local-preference
Change the default local preference value for routes exchanged between internal BGP peers.
C9000 Series
Syntax
bgp default local-preference value
To return to the default value, use the no bgp default local-preference
command.
Parameters
value Enter a number to assign to routes as the degree of
preference for those routes. When routes are compared, the
higher the degree of preference or local preference value,
the more the route is preferred. The range is 0 to
4294967295. The default is 100.
Defaults 100
Command Modes ROUTER BGP
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.2.1.0 Introduced on the E-Series ExaScale.
7.4.1.0 Introduced
Usage Information The bgp default local-preference command setting is applied by all routers
within the AS.
bgp enforce-first-as
Disable (or enable) enforce-first-as check for updates received from EBGP peers.
C9000 Series
Syntax
bgp enforce-first-as
To turn off the default, use the no bgp enforce-first-as command.
Defaults Enabled.
Command Modes ROUTER BGP
538
Border Gateway Protocol