Reference Guide

Version Description
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information By default, when you create a neighbor/peer group configuration in the Router
BGP context, this enables IPv4/Unicast AFI/SAFI. When you use activate in the
new context, the neighbor/peer group enables for AFI/SAFI.
neighbor add-path
This command allows the specified neighbor/peer group to send/receive multiple path advertisements.
C9000 Series
Syntax
neighbor [ip-address | peer-group-name] add-path [send |
receive | both] path-count
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted
decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group.
send Enter the keyword send to indicate that the system sends
multiple paths to peers.
receive Enter the keyword receive to indicate that the system
accepts multiple paths from peers.
both Enter the keyword both to indicate that the system sends
and accepts multiple paths from peers.
path-count Enter the number paths supported. The range is from 2 to
64.
Defaults none
Command Modes CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Inroduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Border Gateway Protocol
433