Reference Guide

default-metric
Allows you to change the metric of redistributed routes to locally originated routes. Use this command
with the redistribute command.
C9000 Series
Syntax
default-metric number
To return to the default setting, use the no default-metric command.
Parameters
number Enter a number as the metric to be assigned to routes from
other protocols. The range is from 1 to 4294967295.
Defaults 0
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
The default-metric command in BGP sets the value of the BGP
MULTI_EXIT_DISC (MED) attribute for redistributed routes only.
Related
Commands
bgp always-compare-med — enables comparison of all BGP MED attributes.
redistribute — redistributes routes from other routing protocols into BGP.
deny bandwidth
Specify link bandwidth extended-community attribute as the matching criteria to deny incoming or
outgoing traffic.
Syntax
deny bandwidth
428
Border Gateway Protocol