Reference Guide

Defaults None
Command Modes DOT1X PROFILE CONFIG (conf-dot1x-profile)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
The mac command configures a list of supplicant MAC addresses for a dot1x profile
represented with a profile-name. You can configure up to 6 MAC addresses in a
single mac command. The maximum number of MAC addresses that you can
configure in a single profile is limited to 128.
Example
Dell(conf)#dot1x profile mySupplicants
Dell(conf-dot1x-profile)#mac 00:50:56:AA:01:10 00:50:56:AA:
01:11
Dell(conf-dot1x-profile)#show config
dot1x profile mySupplicants
mac 00:50:56:aa:01:10
mac 00:50:56:aa:01:11
Dell(conf-dot1x-profile)#
Dell(conf-dot1x-profile)#exit
show dot1x cos-mapping interface
Display the CoS priority-mapping table the RADIUS server provides and applies to authenticated
supplicants on an 802.1X-enabled system.
C9000 Series
Syntax
show dot1x cos-mapping interface interface [mac-address mac-
address]
Parameters
interface Enter one of the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
802.1X
243