Reference Guide

Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage Information
Use this command to associate a management port with a management VRF.
When you execute this command, the management ports corresponding to both
the ACTIVE unit as well as the STANDBY unit are associated with the management
VRF.
maximum dynamic-routes
Specify the maximum number of dynamic (protocol) routes a VRF can have.
C9000 Series
Syntax maximum dynamic-routes limit {warn-threshold threshold-value |
warning-only}
To remove the limit on the maximum number of routes used, use the no maximum
dynamic-routes command.
Parameters
limit Maximum number of routes allowed in a VRF. Valid range is
from 1 to 16,000 (or maximum allowable for that platform if
smaller value).
warning-
threshold
Warning threshold value is expressed as a percentage of the
limit value. When the number of routes reaches the
specified percentage of the limit, a warning message is
generated. Valid range is 1 to 100. When warn-threshold is
used, once the limit is reached, additional dynamic routes
will not be allowed.
warning-only When the warning-only option is used, a syslog message
will be thrown when maximum number of dynamic routes
Virtual Routing and Forwarding (VRF)
2107