Reference Guide

pool of routes, when the destination VRF imports global

routes, these routes will be duplicated into the VRF's RTM.

As a result, it is mandatory to use route-maps to filter out

leaked routes while sharing global routes with VRFs.

Defaults N/A

Command Modes

VRF MODE

CONFIGURATION

Command History

Version Description

9.9(0.0) Introducued on the C9010.

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000–

ON, and Z9500.

Usage Information You can use the ip route-export tag command without specifying the route-

map attribute to export all the routes corresponding to a source VRF. This action

exposes source VRF's routes to various other VRFs, which then import these routes

using the ip route-import tag command. In Dell Networking OS, you can

configure at most one route-export per VRF as only one set of routes is exposed

for leaking. However, you can configure multiple route-import targets because a

VRF accepts routes from multiple VRFs.

You can expose a unique set of routes from the source VRF for leaking to other

VRFs. When two VRFs leak or export routes, there is no option to discretely filter

leaked routes from each source VRF. You cannot import one set of routes from

one VRF and another set of routes from another VRF.

Only active routes are eligible for leaking. For example, if one VRF has two routes

corresponding to BGP and OSPF, in which the BGP route is not active, the OSPF

route takes precedence over BGP. Even though the Target VRF has specified

filtering options to match BGP, the BGP route is not leaked as that route is not

active in the Source VRF.

Commands

ipv6 route-import – imports IPv6 routes from another VRF.

Virtual Routing and Forwarding (VRF)

2103