Reference Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series.
Support was added for IPv6 VRRP groups in non-default
VRF instances.
8.3.2.0 Introduced on the E-Series TeraScale.
Usage Information If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the Dell Networking OS returns
No Active VRRP group.
C9000 Series
Syntax
show vrrp ipv6 [vrid] [interface] [brief][vrf vrf-name]
Parameters
vrid (OPTIONAL) Enter the virtual router identifier for the VRRP
group to view only that group. The range is from 1 to 255.
interface Enter the following keywords and slot/port or number
information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then the
VLAN ID. The VLAN ID range is from 1 to 4094.
brief (OPTIONAL) Enter the keyword brief to view a table of
information on the VRRP groups.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
view IPv6 VRRP groups corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Virtual Router Redundancy Protocol (VRRP)
2093