Reference Guide

vrrp delay minimum
Set the delay time for VRRP initialization after an interface comes up.
C9000 Series
Syntax
vrrp delay minimum seconds
Parameters
seconds Enter the number of seconds for the delay for VRRP
initialization after an interface becomes operational. The
range is from 0 to 900 (0 indicates no delay).
Defaults 0
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information
This command applies to a single interface. When used with the vrrp delay
reload CLI, the later timer rules the VRRP enabling. For example, if vrrp delay
reload
is 600 and the vrrp delay minimum is 300:
• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up
VRRP on all interfaces that are up and configured for VRRP.
• When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
Related Command vrrp delay reload — sets the delay time for VRRP initialization after a system reboot.
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
C9000 Series
Syntax
vrrp delay reload seconds
Virtual Router Redundancy Protocol (VRRP)
2087