Reference Guide

Version Description
8.3.8.0 Introduced on the S4810.
Usage Information The VLT domain ID must be the same between the two VLT devices. If the domain
ID is not the same, a syslog message is generated and VLT does not launch.
Related
Commands
show vlt — uses the show vlt brief command to display the delay-restore
value.
vlt-peer-lag port-channel
Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to
an attached device.
C9000 Series
Syntax
vlt-peer-lag port-channel id-number
Parameters
id-number Enter the respective vlt port-channel number of the peer
device.
Defaults Not configured.
Command Modes INTERFACE PORT-CHANNEL
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
2064
Virtual Link Trunking (VLT)