Reference Guide

Usage Information
You can configure up to eight allow-remote entries on any multipoint receive-only
tunnel.
This command fails if the address family entered does not match the outer header
address family of the tunnel mode, tunnel source, or any other tunnel allow-
remote.
If you configure any allow-remote , the tunnel source or tunnel mode commands
fail if the outer header address family does not match that of the configured allow-
remote.
tunnel destination
Set a destination endpoint for the tunnel.
C9000 Series
Syntax
tunnel destination {ip-address | ipv6–address}
To delete a tunnel destination address, use the no tunnel destination {ip-
address | ipv6–address} command.
Parameters
ip-address Enter the destination IPv4 address for the tunnel.
ipv6–address Enter the destination IPv6 address for the tunnel.
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
Usage Information
The tunnel interface is inoperable without a valid tunnel destination address for the
configured Tunnel mode.
To establish a logical tunnel to the particular destination address, use the
destination address of the outer tunnel header. If you configure a tunnel interface
or source address, the tunnel destination must be compatible.
Tunneling Commands
2023