Reference Guide

ip ssh server
Configure an SSH server. The SSH server is enabled by default.
C9000 Series
Syntax
NOTE: Some of the parameters in this command require licensing to access.
For more information, contact your Dell Networking representative.
ip ssh server {ciphers cipher-list} {enable | port port-number}
[kex key-exchange-algorithm] [mac hmac-algorithm] [version {1 |
2}]
To disable SSH server functions, use the no ip ssh server {ciphers
cipher-list} {enable | port port-number} [kex key-exchange-
algorithm
] [mac hmac-algorithm] [version {1 | 2}] command.
Parameters
enable Enter the key word enable to start the SSH server.
ciphers cipher-list Enter the keyword ciphers and then a space-delimited list
of ciphers that the SSH server supports.
The following ciphers are available.
• 3des-cbc
• aes128-cbc
• aes192-cbc
• aes256-cbc
• aes128-ctr
• aes192-ctr
• aes256-ctr
The default cipher list is used.
• 3des-cbc
• aes128-cbc
• aes192-cbc
• aes256-cbc
• aes128-ctr
• aes192-ctr
• aes256-ctr
mac hmac-
algorithm
Enter the keyword mac then a space-delimited list of hash
message authentication code (HMAC) algorithms supported
by the SSH server for keying hashing for the message
authentication.
Security
1869