Reference Guide

distribute-list in
Configure a filter for incoming routing updates.
C9000 Series
Syntax
distribute-list prefix-list-name in [interface]
To delete the filter, use the no distribute-list prefix-list-name in
command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
interface (OPTIONAL) Identifies the interface type slot/port as one of
the following:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.29.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Routing Information Protocol (RIP)
1773