Reference Guide

Parameters
pe pe-id Enter the keyword pe and port extender ID. Range is from 0
to 255.
stack-unit unit
number
Enter the keyword stack-unit and the unit number.
Range is from 0 to 7.
Defaults None
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
The upgrade poe-controller pe command is used to manually upgrade the
PoE controller firmware for a specified port extender unit.
You can upgrade the PoE controller firmware using the firmware image that is
packed with the Dell Networking OS. Once the upgrade is successful, the Port
Extender reloads automatically.
Example
Dell#upgrade poe-controller pe 254 stack-unit 1
show power inline
Display the PoE power allocation on a specified port extender.
C9000 Series
Syntax
show power inline {pe pe-id stack-unit unit number | interface
interface }
Parameters
pe pe-id Enter the keyword pe and the port extender ID. Range is
from 0 to 255.
stack-unit unit
number
Enter the keyword stack-unit and the stack unit number
Range is from 0 to 7.
interface interface
Enter the interface keyword, and specify one of the
following interface types:
• For a PE Gigabit Ethernet interface, enter the keyword
peGigE. You must specify a pe-id/Unit/Port for the
interface.
1652
Port Extenders (PE)