Reference Guide

DELL(conf-pe-10)#stack-unit 0 type c1048P
Related
Commands
• stack-unit – add or delete a specified port extender stack-unit.
• show pe —display the port extender status and details.
pe provision
Logically provision or add a port extender (PE).
C9000 Series
Syntax
pe provision pe-id
To de-provision or delete a port extender, use the no pe provision pe-id
command.
Parameters
pe provision pe-id Enter port-extender configuration mode to logically
provision a port extender. Port extender ID range is from 0
to 255
Default None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Usage Information
Before you provision a port extender, enable the extended bridge feature using the
feature extended—bridge command. The pe provision pe-id command
logically pre-provisions or adds a port extender (PE) even when the PE is not
physically connected to the switch. The port extender ID (pe-id) range is from 0 to
255.
After provisioning a PE using the pe provision pe-id , you can provision a
stack unit using the stack-unit command.
To de-provision a port extender, use the no pe provision pe-id command.
NOTE: You must ensure that the port extender units are offline before you
issue the no pe provision command.
Port Extenders (PE)
1619