Reference Guide

PIM-Sparse Mode (PIM-SM)

The protocol-independent multicast sparse-mode (PIM-SM) commands in this section are supported in

the Dell Networking operating system.

IPv4 PIM-Sparse Mode Commands

The following describes the IPv4 PIM-sparse mode (PIM-SM) commands.

clear ip pim rp-mapping

The bootstrap router (BSR) feature uses this command to remove all or particular rendezvous point (RP)

advertisement.

C9000 Series

Syntax

clear ip pim rp-mapping [rp-address]

Parameters

rp-address (OPTIONAL) Enter the RP address in dotted decimal format

(A.B.C.D).

Command Modes EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms,

see the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.5(0.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.1.1.0 Introduced on the E-Series ExaScale.

7.8.1.0 Introduced on the S-Series.

PIM-Sparse Mode (PIM-SM)

1571