Reference Guide

Defaults 1
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series on port-channels and the S-
Series.
Usage Information The router with the largest value assigned to an interface becomes the designated
router. If two interfaces contain the same designated router priority value, the
interface with the largest interface IP address becomes the designated router.
ip pim neighbor-filter
To prevent a router from participating in protocol independent multicast (PIM), configure this feature.
C9000 Series
Syntax
ip pim neighbor-filter {access-list}
To remove the restriction, use the no ip pim neighbor-filter {access-
list} command.
Parameters
access-list Enter the name of a standard access list. Maximum 16
characters.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
PIM-Source Specific Mode (PIM-SSM)
1561