Reference Guide

39
PE Stacking
Use the commands in this chapter to configure and manage C1048P port-extender (PE) stacking.
Stacking is not supported on C9010 switches.
For information about using the PE stacking feature, see the “Port Extender (PE) Stacking” chapter in the
Dell Networking OS Configuration Guide for the C9000 Series.
You can use the commands to pre-configure a port extender, so that the configuration settings are
invoked when the switch is attached to the chassis.
renumber
To rearrange the stack units, reassign a stack unit ID number.
C9000 Series
Syntax
pe pe-id stack-unit unit number renumber unit number
Parameters
pe pe-id Enter the keyword pe and the PE ID. The range is from 0 to
255.
stack-unit unit
number
Enter the keyword stack-unit and the stack-unit ID
number. The range is from 0 to 7.
renumber unit
number
Enter the keyword renumber and a new stack-unit ID
number. The range is from 0 to 7.
Default Default stack-unit number is zero.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
Example
Dell# pe 255 stack-unit 0 renumber 2
1530
PE Stacking