Reference Guide

Loopback 0 is up, line protocol is up
Internet Address 192.168.253.2/32, Area 0.0.0.1
Process ID 1, Router ID 192.168.253.2, Network Type
LOOPBACK, Cost: 1
Loopback interface is treated as a stub Host.
Dell>
show ip ospf neighbor
Display the OSPF neighbors connected to the local router.
C9000 Series
Syntax
show ip ospf [process-id |vrf vrf-name] neighbor
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
vrf vrf-name Enter the keyword vrf and the name of the VRF to view
information corresponding to the OSPF neighbors that are
tied to a specific VRF.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.4(0.0) Added support for VRF on all platforms (Except MXL and
STOMP).
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information The following describes the show ip ospf process-id neighbor command
shown in the following example.
Open Shortest Path First (OSPFv2 and OSPFv3)
1459