Reference Guide

Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information Use this command to create an object that tracks the routing state of an IPv4 Layer
3 interface:
• The status of the IPv4 interface is UP only if the Layer 3 status of the interface is
UP and the interface has a valid IP address.
• The Layer 3 status of an IPv4 interface goes DOWN when its Layer 3 status goes
down (for a Layer 3 VLAN, all VLAN ports must be down) or the IP address is
removed from the routing table.
Related
Commands
• show track – displays information about tracked objects, including
configuration, current state, and clients which track the object.
• track interface line-protocol – configures object tracking on the line-protocol
state of a Layer 2 interface.
track interface line-protocol
Configure object tracking on the line-protocol state of a Layer 2 interface.
C9000 Series
Syntax
track object-id interface interface line-protocol
To return to the default setting, use the no track object-id command.
Parameters
object-id Enter the ID number of the tracked object. The range is 1 to
500.
interface Enter one of the following values:
• For a 1-Gigabit Ethernet interface, enter
gigabitethernet and the slot-number/ port-number.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
1376
Object Tracking