Reference Guide

NOTE: If you do not specify this option, neighbors
corresponding to the default VRF are displayed.
cpu rp Enter the keywords cpu rp to display information about
IPv6 neighbors learned only on the Route Processor.
ipv6–address Enter the IPv6 address of a neighbor to display information
about the specified device.
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x
format.
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
interface interface Enter the keyword interface then the interface type and
slot/port or number information:
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Usage Information
When you issue the show ipv6 neighbors without specifying any options, it will
display all IPv6 neighbor addresses stored on the control processor (CP).
Example
Dell#show ipv6 neighbors
* - Active session role
Ad Dn - Admin Down
B - BGP
C - CLI
1364
Neighbor Discovery Protocol (NDP)