Reference Guide

debug ip msdp
Turn on MSDP debugging.
C9000 Series
Syntax
debug ip msdp {event peer address | packet peer address | pim}
To turn debugging off, use the no debug ip msdp {event peer address |
packet peer address | pim} command.
Parameters
event peer
address
Enter the keyword event then the peer address in a dotted
decimal format (A.B.C.D.).
packet peer
address
Enter the keyword packet then the peer address in a dotted
decimal format (A.B.C.D.).
pim Enter the keyword pim to debug advertisement from PIM.
Defaults Not configured.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
6.2.1.1 Introduced
ip msdp cache-rejected-sa
Enable an MSDP cache for the rejected source-active entries.
C9000 Series
Syntax
ip msdp cache-rejected-sa {number}
1314
Multicast Source Discovery Protocol (MSDP)