Reference Guide

Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.) Introduced on the C9010.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
E-Series legacy
command
Usage Information Network administrators use static mroutes to control the reach-ability of the
multicast sources. If a PIM-registered multicast source is reachable using static
mroute as well as unicast route, the distance of each route is examined and the
route with shorter distance is the one the PIM selects for reach-ability.
NOTE: The default distance of mroutes is zero (0) and is CLI configurable on a
per route basis.
Example
Dell#show ip rpf
RPF information for 10.10.10.9
RPF interface: Gi 3/4
RPF neighbor: 165.87.31.4
RPF route/mask: 10.10.10.9/255.255.255.255
RPF type: unicast
IPv6 Multicast Commands
.This section describes the IPv6 multicast commands.
debug ipv6 mld_host
Enable the collection of debug information for MLD host transactions.
C9000 Series
Syntax
[no] debug ipv6 mld_host [int-count | interface type] [slot/
port-range]
1308
Multicast