Reference Guide

Usage Information
To return VLAN 1 as the Default VLAN, use this command syntax (default-vlan-
id 1).
The Default VLAN contains only untagged interfaces.
Related
Commands
interface vlan — configures a VLAN.
default-vlan disable
Disable the default VLAN so that all switchports are placed in the Null VLAN until they are explicitly
configured as a member of another VLAN.
C9000 Series
Defaults Enabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced
Usage Information The no default vlan disable command is not listed in the running-
configuration, but when the default VLAN is disabled, default-vlan disable is
listed in the running-configuration.
name
Assign a name to the VLAN.
C9000 Series
Syntax
name vlan-name
To remove the name from the VLAN, use the no name command.
Parameters
vlan-name Enter up to 32 characters as the name of the VLAN.
Layer 2
1241