Reference Guide

The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell# show cam mac linecard 1 port-set 0
PVlanId Mac Address Region Interface
1 00:01:02:03:04:09 DYNAMIC Fo 2/0
0 74:86:7a:ff:6f:1c LOCAL_DA 00001
1 00:11:22:33:44:55 STATIC Fo 2/8
1 00:01:02:03:04:07 DYNAMIC Fo 2/0
1 00:01:02:03:04:08 DYNAMIC Fo 2/0
0 ff:ff:ff:ff:ff:ff STATIC 00001
1 00:01:02:03:04:05 DYNAMIC Fo 2/0
1 00:01:02:03:04:06 DYNAMIC Fo 2/0
show mac-address-table
Display the MAC address table.
C9000 Series
Syntax
show mac-address-table [address mac-address | interface
interface | vlan vlan-id] [aging-time] [dynamic | static]
[count [vlan vlan-id] [interface interface-type [slot [/
port]]]]
Parameters
address mac-
address
(OPTIONAL) Enter the keyword address then a MAC
address in the nn:nn:nn:nn:nn:nn format to display
information on that MAC address.
dynamic (OPTIONAL) Enter the keyword dynamic to display only
those MAC addresses the switch dynamically learns.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
static (OPTIONAL) Enter the keyword static to display only
those MAC addresses specifically configured on the switch.
Optionally, you can also add one of these combinations:
address/mac-address, interface/interface, or vlan
vlan-id.
1234
Layer 2