Reference Guide

In a VLT configuration, show iscsi session output is not accurate unless there
are iSCSI traffic flows on VLT LAGs on both the target and the initiator side of the
VLT domain.
Related
Commands
• show iscsi — displays the currently configured iSCSI settings.
• show iscsi session detailed— displays detailed information about active iSCSI
sessions on the switch.
• show run iscsi— shows run iscsi.
show iscsi session detailed
Display detailed information on active iSCSI sessions on the switch.
C9000 Series
Syntax
show iscsi session detailed [session isid]
Parameters
isid Enter the session’s iSCSi ID to display detailed information
about the specified iSCSi session.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.6(0.0) Introduced on the Z9500.
Example
Dell# show isci session detailed
Session 0 :
---------------------------------------------------
Target:iqn.2010-11.com.ixia:ixload:iscsi-TG1
Initiator:iqn.2010-11.com.ixia.ixload:initiator-iscsi-2c
Up Time:00:00:01:28(DD:HH:MM:SS)
Time for aging out:00:00:09:34(DD:HH:MM:SS)
ISID:806978696102
Initiator Initiator Target Target Connection
IP Address TCP Port IP Address TCPPort ID
10.10.0.44 33345 10.10.0.101 3260 0
Session 1 :
----------------------------------------------------
Target:iqn.2010-11.com.ixia:ixload:iscsi-TG1
1220
iSCSI Optimization