Reference Guide

Related
Commands
show ipv6 route — views the IPv6 configured routes.
ipv6 unicast-host-route
Enable the storage of extended IPv6 route prefixes (/65 to /128) in the L3 host table.
C9000 Series
Syntax
[no] ipv6 unicast-host-route
Defaults Enabled; by default, extended IPv6 route prefixes are stored only in the L3 host
table.
Command Modes CONFIGURATION
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.3(0.1) Introduced on the S6000.
Usage Information Use this command to enable programming of extended IPv6 (/65 to /128) route
prefixes in the L3 host table. A warning message is displayed after you enter the
command stating that this setting takes effect for existing routes only when IPv6
route prefixes are cleared from the LPM routing table (RTM). To enable storage of
extended IPv6 route prefixes in the LPM table, disable this setting by entering the
no ipv6 unicast-host-route command.
Example
Dell(conf)# ipv6 unicast-host-route
Warning: Command will take effect for existing routes only
when IPv6
route prefixes are cleared from RTM
Dell(conf)#no ipv6 unicast-host-route
Warning: Command will take effect for existing routes only
when IPv6
route prefixes are cleared from RTM
Dell(conf)#
ipv6 unicast-routing
Enable IPv6 Unicast routing.
C9000 Series
Syntax
ipv6 unicast-routing
IPv6 Basics
1199