Reference Guide

show ip traffic
View IP traffic statistics related to switch CPUs, including ICMP, UDP, TCP and ARP counters.
C9000 Series
Syntax
show ip traffic {all | cp | rp}
Parameters
all (OPTIONAL) Enter the keyword all to view IP traffic
statistics from all processors.
cp (OPTIONAL) Enter the keyword cp to view only IP traffic
statistics from the Control Processor.
rp (OPTIONAL) Enter the keyword rp to view only IP traffic
statistics from the Route Processor.
Default View IP traffic statistics from all processors.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the show ip traffic summary shown in the following
example.
Keyword Definition
unknown
protocol...
No receiver for these packets. Counts packets whose
protocol type field is not recognized by the system.
not a gateway... Packets can not be routed; the host/network is unreachable.
security failures... Counts the number of received unicast/multicast packets
that could not be forwarded due to:
IPv4 Routing
1153