Reference Guide

rp Enter the keyword rp to display the interface statistics only
from the Route Processor.
linecard slot-id Enter the linecard slot-id parameters to display the
interface statistics only from a specified line card. The range
of line-card slot IDs is from 0 to 11.
all Enter the keyword all to display the interface statistics
from all switch CPUs, including the Control Processor,
Route Processor, and line cards.
Defaults Display interface statistics from all switch CPUs.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series
6.2.1.1 Introduced on the E-Series.
Usage Information Traffic statistics are sorted on a per-interface basis; the interface receiving the most
traffic is displayed first. All CPU and port information is displayed unless a specific
port or CPU is specified. Traffic information is displayed for router ports only; not
for management interfaces.
Example
Dell#show cpu-traffic-stats cp
-- Partybus ethernet statistics --
Link state : Up
Recv Interrupts/Polls: 0
Recv Packets : 2027080 Transmit Packets :
590000
Recv Desc Error : 0 Transmit Desc
Error : 0
Recv Out of Mem : 0 Transmit Out of
Mem : 0
Recv Upper Layer Full: 0 Transmit Pause
Pkts : 0
Recv Other Error : 0 Transmit Other
Error: 0
Recv Restarts : 0
Recv Restarts Fatal : 0
Control and Monitoring
115