Reference Guide

Version Description
6.1.1.0 Introduced on the E-Series.
Example
Dell>show ip fib linecard 2
Destination Gateway First-
Hop Mac-Addr Port VId EC
----------------------------------------------------------------
------------------- ----------------- ------------
1.1.32.140/32 via 1.1.32.140, PeGigE PE‐ID/Slot/Port
1.1.32.140 00:00:00:00:1f:8a PeGigE PE‐ID/Slot/Port 200 0
show ip flow
Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
C9000 Series
Syntax
show ip flow interface interface {source-ip address
destination-ip address} {protocol number [tcp | udp]} {src-port
number destination-port number}
Parameters
interface interface Enter the keyword interface then one of the following
interface keywords.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
source-ip address Enter the keywords source-ip then the IP source address
in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP
destination address in IP address format.
protocol number
[tcp | udp]
Enter the keyword protocol then one of the protocol type
keywords: tcp, udp, or protocol number The protocol
number range is from 0 to 255. .
src-port number Enter the keywords src-port then the source port number.
destination-port
number
Enter the keywords destination-port then the
destination port number.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
IPv4 Routing
1139