Reference Guide

• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. For the C-Series and S-Series,
the range is from 1 to 128.
Defaults Not configured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Usage Information Dell Networking OS provides the capability of statically configuring the interface to
which a multicast router is attached. To configure a static connection to the
multicast router, enter the ip igmp snooping mrouter interface command
in the VLAN context. The interface to the router must be a part of the VLAN where
you are entering the command.
ip igmp snooping querier
Enable IGMP querier processing for the VLAN interface.
C9000 Series
Syntax
ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp
snooping querier command.
Defaults Not configured.
Internet Group Management Protocol (IGMP)
1077