Reference Guide

ip igmp query-interval
Change the transmission frequency of IGMP general queries the Querier sends.
C9000 Series
Syntax
ip igmp query-interval seconds
To return to the default values, use the no ip igmp query-interval
command.
Parameters
seconds Enter the number of seconds between queries sent out. The
range is from 1 to 18000. The default is 60 seconds.
Defaults 60 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.1) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON. Maximum range of the Hello
interval value is changed to 18000.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to
enable the system to act as an IGMP Proxy Querier.
E-Series legacy
command.
Internet Group Management Protocol (IGMP)
1061