Reference Guide

• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
vrf vrf-name (OPTIONAL) Enter the keyword vrffollowed by the name of
the VRF to display adjacent router information
corresponding to that VRF
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information
Use this command to confirm that the neighbor adjacencies are operating
correctly. If you suspect that they are not, you can verify the specified area
addresses of the routers by using the show isis neighbors command.
The following describes the show isis neighbors command shown in the
following example.
Field Description
System Id The value that identifies a system in an area.
Interface The interface, slot, and port in which the router was
discovered.
State The value providing status about the adjacency state. The
range is Up and Init.
Type This value displays the adjacency type (Layer 2, Layer 2 or
both).
1046
Intermediate System to Intermediate System (IS-IS)