Reference Guide

Related
Commands
lsp-refresh-interval — sets the link-state packet (LSP) refresh interval.
maximum-paths
Configure the maximum number of equal cost paths allowed in a routing table.
C9000 Series
NOTE: You can use the maximum-paths command to configure a single system wide value that is
common for both IPv4 and IPv6 addresses.
Syntax
maximum-paths number
To return to the default values, use the no maximum-paths command.
Parameters
number Enter a number as the maximum number of parallel paths
an IP routing installs in a routing table. The range is from 1
to 64. The default is 4.
Defaults 4
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Added support for multi-topology ISIS.
6.3.1.0 Introduced.
1024
Intermediate System to Intermediate System (IS-IS)