Reference Guide

Parameters

adjacency Enter the keyword adjacency so that the restarting router

receives the remaining time value from its peer and adjusts

its T3 value so if you have configured this option.

manual Enter the keyword manual to specify a time value that the

restarting router uses. The range is from 50 to 120 seconds.

The default is 30 seconds.

Defaults manual, 30 seconds

Command Modes ROUTER ISIS

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.9(0.0) Introduced on the C9010.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

8.3.1.0 Introduced on the E-Series.

Usage Information

The running router sets the remaining time value to the current adjacency hold

time. You can override this setting by implementing this command.

Override the default restart-wait time by entering the no graceful-restart

restart-wait command. When you disable restart-wait, the current

adjacency hold time is used.

Set the t3 timer to adjacency on the restarting router when implementing this

command. The restarting router gets the remaining time value from its peer and

adjusts its T3 value so only when you have configured graceful-restart t3

adjacency.

Commands

graceful-restart restart-wait — enables the graceful restart maximum wait time

before a restarting peer comes up.

Intermediate System to Intermediate System (IS-IS)

1001