Concept Guide
Enabling DHCP Snooping
To enable DHCP snooping, use the following commands.
1 Enable DHCP snooping globally.
CONFIGURATION mode
ip dhcp snooping
2 Specify ports connected to DHCP servers as trusted.
INTERFACE mode
ip dhcp snooping trust
3 Enable DHCP snooping on a VLAN.
CONFIGURATION mode
ip dhcp snooping vlan name
Adding a Static Entry in the Binding Table
To add a static entry in the binding table, use the following command.
• Add a static entry in the binding table.
EXEC Privilege mode
ip dhcp snooping binding mac mac-address vlan-id vlan-id ip ip-address interface interface-
type interface-number lease lease-value
If multiple IP addresses are expected for the same MAC address, repeat this step for all IP addresses.
Clearing the Binding Table
To clear the binding table, use the following command.
• Delete all of the entries in the binding table.
EXEC Privilege mode
clear ip dhcp snooping binding
Displaying the Contents of the Binding Table
To display the contents of the binding table, use the following command.
• Display the DHCP snooping information.
EXEC Privilege mode
show ip dhcp snooping
• Display the contents of the binding table.
EXEC Privilege mode
show ip dhcp snooping binding
364
Dynamic Host Conguration Protocol (DHCP)