Administrator Guide

2. Using a flat-tipped screwdriver, remove the bracket subassembly and four pins (items 1, 2, and 4 in
Figure 15) from the front and rear of each rail. Pull on each subassembly to fully remove it.
Figure 15. Installing Tooled Rails in a Threaded-Hole Rack
3. Attach the front of each rail to the front rack posts using the screws provided with the rack.
On a 4-post rack, slide the back end of each rail so that it aligns with the back post holes at the same
height. Attach each rail to a rear post using four screws provided with the rack (item 4 in Figure 15).
24
Installing the Hardware